Retard Meaning in Aviation

At 20 ft radio altitude on a normal Airbus landing, “RETARD” means reduce the thrust levers to idle. In aviation generally, retard means to reduce, slow, or delay something, not a description of a person. The word’s precise meaning depends on what is being retarded and, for a cockpit callout, on the phase of flight.

What Retard Means in Aviation

In technical aviation language, retard is a verb meaning “reduce” or “slow.” It can apply to engine thrust, aircraft motion, ignition timing, or another system effect.

Common uses include:

  • Retard thrust: reduce engine power or commanded thrust.
  • Retard the throttles: an older and still understandable way of saying to move engine controls toward lower thrust. On transport jets, the controls are more commonly called thrust levers.
  • Retard ignition timing: make the spark occur later in an engine cycle.
  • Retardation: the act or rate of slowing down; in flight discussions, this can mean deceleration.

The opposite word in cockpit-control language is usually advance: advancing a thrust lever means moving it forward toward greater selected thrust.

“RETARD” is also a specific automated aural alert. It is not merely a general reminder to slow the airplane down.

Why Airbus Says RETARD During Landing

The Airbus RETARD callout is designed for the landing flare, when the airplane is very close to the runway. The radio-altitude measurement refers to height above the surface directly below the aircraft, rather than the altitude shown by a barometric setting.

Airbus’s RETARD alert is intended to prompt the pilots to move the thrust levers to idle for landing. It is a normal part of the landing sequence when it occurs at the expected point in a stable approach, not an automatic declaration of an emergency.

The timing matters because airliners normally carry some thrust on final approach. Near touchdown, reducing to idle lets the aircraft transition from approach power to landing and rollout.

How Pilots Respond to the RETARD Callout

Airline pilots use their aircraft’s approved procedures, checklists, and operator standard operating procedures.

Use the flight phase to distinguish a normal landing callout from an unexpected alert:

Situation Correct Reading of RETARD Appropriate Response
Normal Airbus landing close to touchdown A routine landing cue at 20 ft radio altitude Reduce thrust levers to idle as part of the approved landing sequence
Takeoff roll or initial climb Not a normal instruction to close the throttles Treat it as an abnormal indication and use the applicable procedures
Passenger hearing the word in the cabin or on a recording A cockpit callout, not a passenger instruction Follow cabin-crew directions and avoid drawing conclusions from one sound

Step 1: Establish the Flight Phase

Pilots first determine whether the aircraft is landing, taking off, climbing, or already on the ground. The same spoken word can mean something very different near touchdown than it would during a takeoff roll.

Step 2: Apply the Normal Landing Response

When RETARD occurs as expected during an Airbus landing, the callout tells the pilot flying to reduce the thrust levers to idle. The crew then continues the landing using its normal procedures and aircraft-specific guidance.

The alert is directed at the flight crew. It is not a command for a passenger, an observer, or someone listening to cockpit audio to interpret as an immediate danger signal.

Step 3: Treat an Unexpected Alert as an Abnormal Event

An unexpected RETARD callout, especially on takeoff, is an abnormal event. Pilots assess the aircraft’s indications, annunciations, performance, and checklist requirements before taking action.

Why RETARD During Takeoff Is Different

RETARD is designed as a landing callout, so hearing it during takeoff is not normal and does not mean “pull the thrust levers to idle.”

An example occurred during a takeoff accident. The RETARD alert sounded as the aircraft reached 86 KIAS, while the flight management computer could no longer carry out the planned FLEX-power takeoff and the required V-speeds were not displayed.

In that event, an ECAM message indicated that thrust was not set. Under the operator’s procedures for that specific condition, the thrust levers were to be moved to the TO/GA detent, the takeoff/go-around thrust-lever position. Simulator testing found that this action would have silenced the RETARD alert. The accident facts and the landing design of the alert are documented in the NTSB final report.

That detail is important, but narrow: TO/GA was the required response to the specific ECAM condition and operator procedure in that case.

The report describes FLEX temperature as a reduced takeoff thrust setting. If the aircraft cannot use that setting as expected, the system state, thrust-lever position, and takeoff data can no longer be treated as routine.

What Travelers Should Take From a Cockpit Callout

For travelers, RETARD heard during landing is a cockpit cue to reduce the thrust levers to idle.

Departure callouts, videos, and accident recordings may involve different aircraft types, stages of flight, warning messages, thrust settings, and crew procedures.

If you are trying to identify what you heard:

  • Confirm whether the airplane was landing or taking off.
  • For a reported incident, look for an airline statement or an official investigation rather than relying on isolated audio or social-media commentary.
  • If the issue concerns an actual flight you were on, keep the flight number, date, and route when contacting the airline.

Frequently Asked Questions

What Does RETARD Mean Just Before a Jet Lands?

On an Airbus, RETARD is a landing cue: at 20 ft radio altitude, it tells the pilots to reduce the thrust levers to idle. It normally occurs during the flare, just before touchdown. Other aircraft types may use different callouts or procedures.

Does RETARD Automatically Reduce Engine Thrust?

No. On Airbus aircraft, the RETARD alert advises the pilots to move the thrust levers to idle. The alert itself is a crew prompt, while the aircraft’s automation and engine-control systems continue to operate according to the airplane’s selected mode and configuration.

What Is the Opposite of Retard on Takeoff?

The usual opposite is advance, meaning move the thrust levers forward to select more thrust. On Airbus aircraft, TO/GA is the detent associated with takeoff/go-around thrust, but pilots use it only when their procedures and aircraft condition call for it.

What Is Retardation in Aviation?

Retardation means slowing down or reducing speed, force, or effect. In an aviation context, it may refer to aircraft deceleration, reduced engine thrust, or a system that delays an event or response.

What Does Retard Mean in Automotive Terms?

In automotive use, “retard” commonly means delay ignition timing, so the spark occurs later in the engine cycle. It can also mean reducing an effect, such as retarding engine power or vehicle acceleration. The underlying technical meaning is the same as in aviation: slow, delay, or reduce.

What Does RETARD Mean When an Airplane Is Taking Off?

RETARD during takeoff is not a normal instruction to set thrust to idle. In the event involving a “thrust not set” ECAM message, the applicable operator procedure called for the TO/GA detent instead. If you are researching a departure event, identify the aircraft type and phase of flight, then use the airline’s public information or an official investigation to understand the full context.